The uniCONNECT connector system uses solid blade contacts and highly durable base strips. With this new design, high pin counts in a compact connector can now finally be realized – up to 28 pins. It allows for more than 3000 cycles with load capacities of up to 10A, making it optimal for use in model making.
The blade strips have the advantage that all cables can be reliably and easily soldered without the risk of melting a plastic carrier. Additionally, they include strain relief, locking mechanisms, grips, and kink protection. The contacts on the blade strips are always visible, making it easy to detect any damage or contamination immediately.
The greatest advantage of the system is that it provides double redundancy for important control functions within the connector itself. Therefore, the system distinguishes between primary pins (doubled, for main functions) and secondary pins (single, for lights, landing gear, brakes, etc.), unlike traditional systems that only specify pin counts.
Locking CABLE is a classic connection type where a socket is permanently installed in the fuselage, and the cables from the wing are connected to a plug. This plug is inserted into the socket during assembly and locks in place. The remaining cable is then pushed back into the wing after the plug is connected.
Technical Data:
6 primary contacts for main functions, 10A
4 secondary contacts for additional functions, 5A
3000 cycles,
strain relief, handle and bend protection
Easily accessible contacts and soldering points
Classic connector with secure locking
Pre-assembled with 3m cable (0.35mm²)
Available as a kit with all parts and screws
cover dimensions: 13x63mm
Connector weight: 19g without cable
Purpose of Use:
RTR
Fully assembled and soldered unit with 3m cable, directly connected 1:1. It is installed on one side, the length defined to the servo, and assembled with crimp contacts. The remaining cable is routed to the receiver side and then assembled. This completed unit is always delivered as a single piece, i.e., 1xM and 1xF
Ready-to-Wire / RTWR:
Pre-assembled connector with free soldering points for custom realization of a servo connection (main functions like ailerons, flaps, etc.). 2 pairs (2xM / 2xF).
DIY Kit:
Kit for a connector with 3 redundant contacts for a primary servo connection (main functions like ailerons, flaps, etc.). For experienced modelers, includes all parts and screws for assembly, 2 pairs (2xM / 2xF).
